Drawer closed switches

User avatar
Mark in Vegas
Posts: 32
Joined: Tue Jan 05, 2016 11:21 am
Contact:

Drawer closed switches

Postby Mark in Vegas » Wed Feb 22, 2017 12:47 pm

The drawer closed switch actuators are bent causing 0020 faults. I have replaced the switches on all our pagewides and shortly after the actuators are bent again. I see no adjustment on the frame mounted tabs and don't see an adjustment to the drawer stops. Am I missing something?

kipdoctor
Site Admin
Posts: 3
Joined: Fri Dec 18, 2015 8:16 pm
Contact:

Re: Drawer closed switches

Postby kipdoctor » Wed Mar 08, 2017 11:18 am

Are you missing something? Well where should I begin?

User avatar
Mark in Vegas
Posts: 32
Joined: Tue Jan 05, 2016 11:21 am
Contact:

Re: Drawer closed switches

Postby Mark in Vegas » Wed Mar 08, 2017 5:58 pm

Maybe, "but I wouldn't say I've missed it, Bob."

cmwade77
Posts: 23
Joined: Thu Jan 21, 2016 2:56 pm
Contact:

Re: Drawer closed switches

Postby cmwade77 » Tue Mar 14, 2017 7:02 pm

I know when we first got our plotter, the people installing it said there was a known issue that caused something like this and they already had the fix for it, so they took care of it then, perhaps this is all that is needed? I would suggest checking through the service bulletins.

User avatar
Mark in Vegas
Posts: 32
Joined: Tue Jan 05, 2016 11:21 am
Contact:

Re: Drawer closed switches

Postby Mark in Vegas » Wed Mar 15, 2017 11:16 am

I'll go back through the knowledge base to see what I missed. Do you remember how long ago your pagewide was installed?


Return to “PageWide XL 8000 Hardware Discussions”

Who is online

Users browsing this forum: No registered users and 1 guest